They would rightly be concerned about the security of your wireless garage door opener and remote. An attacker can gain access to your garage contents, or even at home if you do not follow some simple security steps.
Different frequencies are used for communication between the remote and the opener. Tiny switches that are used as a dip switch to the frequency between the left and setting known. It is a wise idea to configure the dip switch settings to make sure that your garagemore secure.
A DIP switch is a small block of plastic in the size of a cube cut in half. They are usually colored blue or red with 8 to 10 small white gear lever into position up or down. Only when the up / down switch patterns on both devices match your garage door remote control is able to communicate with the opener unit. By adapting the model, a switch, change the radio frequency used to communicate between the two.
You should be able to easilyLocate the DIP switches on the opener and on the remote control clicker. But in order to access the dip switches on the remote control, you may need to get to open it, if the DIP switch is not found in the battery compartment. Remove the screws holding the remote together, or carefully pry it apart, if there are no screws. Once you have access to the dip switches on the remote, kick the switch positions, and then the positions correspond to the opener dip switch block. It does not matter what looks like the pattern,as long as a random pattern that would be difficult to guess.
If you have difficulties that remote to investigate by this method whether the dip switch patterns on both units. Then check the battery of the remote is in good condition, and as always ensure that the opener has the power, and usually works on the control panel in your garage. You may need to read the manual when all else fails.
If you are thinking of a new garage door openeror have already received one, then you will want to change the settings, just to make sure everyone is honest. Do not forget, your installer or someone familiar with working with him your crossover settings unless you change it. So go ahead and mix the sample switch settings and test whether it works.
Even if you have a garage door opener installation do-it-yourself type, you should make the same changes. Not only remain at the factory settings. If so, then allcould only drive your street with a compatible remote control, until he discovers that opens a door and opening access to your home. Make sure that you will not.
This advice applies equally to any purchase or rent a new home. Like you, perhaps the lock to ensure that there are no spare keys in circulation, that your house could affect safety. You have no idea how many previous residence there might have been. And you do not want someone to just the right footin your garage or home.
No comments:
Post a Comment